DuckSouth.com

Folks, I have a savage model 67f in a 410 ga I want to give to a friends son, however it is missing a magazine cap,spring, and spirng follower. I have searched all the sites and gunsmiths here locally and cant find these parts.

please look around and see if you have these parts or next time you are at the gunsmith shop please ask about them for me please.

Try this place www.gun-parts.com/savageshotgun they have them listed on their page Keep in mind that savage, stevens, and springfield are all the same guns and the parts are interchangable.

I have tried them, he doesnt have them in 410 ga thanks

Have you tried cooks guns in diberville, they are usually pretty good with getting parts.

Yes I called them.........thanks

I got one the extractor is FUBAR in, struggling finding parts for. You find a source let me know.

Found this

http://www.gun-parts.com/savageshotgun/

been there......thanks

Brownells

Take it to a real gunsmith and he can make the parts.

LODI QUACKER wrote:Take it to a real gunsmith and he can make the parts.

+1
Mr Ed Sanders out of West Point put an old 1849 Colt pocket revolver back together for me that was missing the hammer spring. He made one for it.
(662) 494-6218

teul2 wrote:

LODI QUACKER wrote:Take it to a real gunsmith and he can make the parts.

+1
Mr Ed Sanders out of West Point put an old 1849 Colt pocket revolver back together for me that was missing the hammer spring. He made one for it.
(662) 494-6218

Those are the easiest parts on a gun to make. SRM Performance Products makes all those parts for other guns. He may make them for that gun, or could no doubt custom make them.