Page 1 of 1
Choke Stuck/Gun
Posted: Sat May 28, 2005 3:58 pm
by Crowell
I have a Benelli that when I try to remove the modified choke, it will not loosen. I took it to the place of purchase, they tried removing the choke after cleaning the gun. They broke a wrench trying to remove the choke. The only solution seems to return to the gun to the manufacturer. Anyone have a similar solution, besides a heating torch?
Thanks.
Posted: Sat May 28, 2005 4:11 pm
by tunica du4u
after not taking choke out of my SBE for bout 3 yrs. it was
STUCK Soaked it down with PB Blaster from both sides left overnight ...was tough comin out but did..PB Blaster is some good chit for rust...
Posted: Sat May 28, 2005 4:13 pm
by gyver
PUG THE END OF THE BARREL, STAND ON THE END AND FILL IT WITH THE PB BLAST TILL YOU FEEL LIKE THE CHOKE IS SUBMERGED. LEAVE IT ALONE FOR 2 DAYS THEN REMOVE.
choke
Posted: Sat May 28, 2005 6:39 pm
by jdbuckshot
soak it in marvel mystery oil for a few days. tap around the choke ever few hours to make sure if it penetrates.
Posted: Sat May 28, 2005 6:42 pm
by gator
sell it and get a real gun
just kiddin, "sorta"
gator
Posted: Sun May 29, 2005 10:53 am
by Spoonallard
Posted: Mon May 30, 2005 10:11 am
by HARLEY
Yeah, that way the jamming problems will outweigh the stuck choke!
If the PB doesnt work try Kroil it is amazing stuff.
Posted: Mon May 30, 2005 10:50 pm
by sondance
you can try heating it after soaking it in PB
Posted: Tue May 31, 2005 6:31 pm
by Crowell
Thanks to the supporters of PB Blaster. I left the choke submerged for almost two days. Got the choke out a few minutes ago. I own a Browning and acknowledge it is a good gun. My Benelli has not presented a jamming problem---yet. Thanks again to the real experts!